I injured myself at work. Been on workers comp for 3 months. Got cleared and now find i out i don't.....

Answers:4   |   LastUpdateAt:2021-06-10 00:30:16  

Question
불가산명사
Asked at 2012-05-19 00:56:37
have a job. What kind of legal action I can take? If I can sue, I can sue to get my job or what? I live in Florida.
Answer1ClifforAnswered at 2012-05-20 00:04:48
You have no action what so ever. Are there any restrictions on their return to work? If you can do with the minimum requirements for the job , they have to stay . Also, I think Floria is a state right to work, and if that's the case , I can let go for any reason. They paid their workers comp , which is all they are responsible. Sorry. You will not get anywhere if you claim as a matter of fact, nobody is likely to take your case, because they know he would not win. I'm sorry, that totally sucks I know. I've been through exactly the same when I was younger , and there was nothing I could do about it.
Answer2PagAnswered at 2012-05-26 13:39:10
Your best bet is to move . In the " right to work" , states like Florida does not have to fire for cause.
Which is to say no, you can not take legal action. Please believe me , go apply for unemployment and tell the whole story . They will give you all the legal answers for free, and you could get some kind of unemployment compensation for a while.
Answer3muleAnswered at 2012-06-10 09:51:53
1) Get a lawyer worker comp that has no money up front.

Is supposed to give you a job that is almost the same as what I was doing before. 2) Call Human Resources if they have that department and ask there.
Answer4 Answered at 2021-06-10 00:30:16

Click here for more details about FAG 51212 bearing.

Surface hardness and hardened layer detection: The surface hardness of the meshing surface of the broken tooth meets the technical requirements. The measured values ​​of the hardened layer in the pitch circle area of ​​the meshing surface of the broken tooth are all lower than the standard requirements. If the depth of the hardened layer is insufficient, the secondary surface cannot withstand the shear stress. The effect will induce fatigue cracks. As the number of load cycles increases, the cracks expand to the surface, and then the tooth surface peels off. As the peeling increases, the effective section of the gear tooth decreases, and finally the gear tooth fractures, but the best hardening for carburizing and quenching To determine the depth of the layer, there is no authoritative theory and method that can be fully accepted by everyone. These theories and methods have always been controversial. The depth of the hardened layer in the pitch circle area of ​​the broken tooth meshing surface may only be a non-standard part of the broken tooth of the gear shaft. Direct factor, but it provides a potential failure basis for fracture accidents.

Related Questions
1
  • Answer This Question:I injured myself at work. Been on workers comp for 3 months. Got cleared and now find i out i don't.....